Bona Polish Remover 1ltr

Removes old layers of Bona Polish and Bona Freshen Up from varnished wooden floors.

1. A concentrated, non-toxic floor polish remover for wooden floors
2. Suitable for water-resistant floor surfaces, such as varnished wood, tiles, PVC and linoleum
3. Effectively removes Bona Polish and Bona Freshen Up from varnished wood floors
4. Effective and easy to use
5. Low odour and solvent-free

Bona Polish Remover effectively removes Bona floor maintenance coatings from wooden floors that have become tired, worn and scuffed prior to re-finishing. Can also be used to remove stubborn shoe scuffs and marks from polished floors. Bona Polish Remover is compatible with the following products:

Bona Polish – A ready-to-use polish for tired varnished floors

Bona Freshen Up – A ready-to-use, Water-based polyurethane maintenance coat to freshen up most finished and pre-finished wooden floors in both commercial and domestic areas.

Preparation

For best results, remove any loose dust, dirt and grit by dry sweeping, using a soft broom, mop or vacuum cleaner prior to applying Bona Polish Remover.

Application

Always do a test area before starting any project to assess product suitability and final finish. Follow the manufacturer’s instructions on the bottle at all times.

Dilution – 1 litre to 5 litres of water. For scuff marks: 1 cap / 100 ml of water.

1. Apply the diluted polish remover to a section of the floor using a Bona Floor Mop or spray applicator
2. Allow the solution approx. 5 minutes to dissolve the polish
3. Scrub the wet section with a hard bristled brush or a scouring pad
4. Wipe off the dissolved material with a mop and bucket of clean water
5. Continue working section by section until the whole floor has been treated
6. Replace the cleaning water frequently
7. Once the polish has been removed, rinse the surface one more time using clean water
8. It may be necessary to repeat this process several times depending on how thick the polish build up is

Please Note: The amount of water applied to the floor must be kept to a minimum so as not to cause any damage. Pay attention to large gaps in the floor and do not allow excessive amounts of cleaning solution to seep into open gaps. It is important that all traces of Bona Polish Remover are wiped up before applying a new layer of polish.

1. For removal of scuff marks: Apply the diluted product to the scuff mark or the affected area
2. After a few minutes scrub with a gentle non-abrasive scouring pad and wipe off any excess

Finishing

Once previous maintenance coatings have been completely removed, a fresh maintenance coat like ones seen in the Overview above can be applied.

IMPORTANT! Do not allow into open gaps in the floor. May cause permanent stain.